Multiple Part Handling Magnet Systems

Permadur Multiple Part Handling Magnet Systems can provide higher productivity and lower costs for both Steel Fabricators and Steel Service Centers by reducing the Material Handling time required to offload Cut Parts and Skeleton.

These systems are designed to:

  • Not drop a suspended load due to loss of electrical power, faulty wiring, or misoperation of controls
  • Consume no power during lift
  • Offer remote control options
  • Need no Back Up Battery System
  • Require no installation costs

Permadur Series 115

This Permadur Series 115 Plate/Multiple Part Handling System was built with 15ea. BP-1600×72 Lifting Magnets on a 10’ load beam. The Magnets are fixed on 8” Centers. The Controller provides Selectivity by Magnet, 15ea., and Permadur’s Exclusive Safety Indicator Lighting System that confirms the Magnets have attached to the load in preparation for a safe lift.

This Controller was also built with System ON/OFF/HIGH Radio Controls in addition to the hard wired PB Pendant Controls. The System also included our Skeleton Picker Frame Assembly to support the separation of Parts/Skeleton at a Parts Separation area.

Finally, the System Load Beam supported attachment to a single hook crane via our Low Headroom Intermediate Beam design.

permadur multiple part handling magnet system series 115-2

Let us do the heavy lifting.

Permadur’s experienced engineering staff is always available to answer your questions about vacuum lifting devices, permanent lifting magnets, and other lifting systems.

Call  908-359-9767 to speak to a Permadur representative today, or fill out our inquiry form.

General Inquiries & Quote Requests

Please submit your information below and a Permadur Customer Service Representative will review the request and contact you shortly.

[contact-form-7 404 "Not Found"]